![]() Therefore I kept trying to solder my points on to my Xbox until it worked again. After re-soldering my JR Programmer points, Jrunner beta 8 consistently started to give the error "Version: 10 Flash Config: 0x00000000 Can not Continue" and I was not able to put my stock NAND back onto my console. After consistently getting the RROD with error code 0010 I attempted to try and put my stock NAND backup back on to my console in order to see if stock firmware would boot. I especially attempted to desolder and resolder my PLL point as that was the trickiest portion to avoid bridging. Attempting to fix that issue I re-soldered any points that appeared to be presenting issues. Assuming it was probably a soldering issue, I attempted to resolver my points and after resoldering my points I began getting the RROD with error code 0010. However, when I was turning on the console there was no sound coming through to my tv from the console. I was able to get it to the point where I was booting Xell and installed operating system on to the console as well and all appeared well. ![]() I recently have attempted to RGH 1.2 my Jasper Xbox 360 using a Coolrunner Rev C and a JR-Programmer V2. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |